Steinberg Systems SBS-MD-12 Bedienungsanleitung Seite 47

3. Press the power button three times for beep and vibration. The device beeps and
vibrates when an object is detected.
The number of emitted sound pulses and vibrations is proportionate to the size of the
object found and the distance to it.
Note! The device will suspend operation after continuously detecting the same target
for approximately 10 seconds to save battery power.
3.3.3. SBS-MD-14
ASSEMBLY
1. Loosen the clamping nut that locks the frame by twisting it. Then insert the lower
tube into the middle tube. Tighten the clamping nut.
2. Press the center tube spring clip into the top handle tube. Align the clip with the
hole.
3. Place the control panel on the top tube and secure with the mounting screw.
4. Plug the search coil cable into the front receptacle on the control panel housing. Do
not force the plug in.