Steinberg Systems SBS-MD-12 Bedienungsanleitung Seite 49

To eliminate the first category, press the DISC button once. To eliminate the second
category, press the DISC button again. The device will not respond to the eliminated
categories.
If the DISC button has not been pressed, the unit will operate in the ALL METAL mode.
All types of metal can be detected.
Category 1.
Target Iron / metal bottle cap
4. To test the efficiency of the device, place it on a wooden or plastic table and
remove all metal jewelry (rings, watches, bracelets) from your hands. Position the
search coil so that it is facing the ceiling. If you want to test the device outdoors,
remember that the search coil should be positioned parallel to the substrate, no more
than 5 cm above the ground. Do not use the device in a swinging manner.
Important!
Never test the device on the floor inside a building. Most floors contain metal
structure elements that may cause the device to malfunction or completely
mask the signal.
5. Pass a metal sample to be detected over the device. The metal target is best kept 5-
7 cm above the search coil. When the device detects the sample, it beeps.
Note! If a coin is used for testing, the device will detect it better if it is placed with its
flat side parallel to the device.
SENSITIVITY ADJUSTMENT [SENS]
Note! To detect a deeply embedded target, set the sensitivity to a high level but not
the highest. Setting the device to the highest sensitivity level will cause it to receive
signals from broadcast antennas or other telecom lines.
2.
Iron / metal bottle caps / screws,
small coins, gold rings, crown caps,
zinc items and certain copper
items.