LITHIUM BATTERY WARNING
CAUTION! This product contains a lithium battery. There is danger of explosion if battery is
incorretly replaced. Replace only with a Maxell CR2032.
Replace only with the correct polarity. Discard used battery according to manufacter's
instruction's.
ADVARSEL! Lithiumbatteri – Eksplosjonsfare. Vade utksifting benyttes kun batteri som anbefalt
av apparatfabrikanten. Brukt batteri returneres apparatleverandøren.
ADVARSEL! Lithiumbatteri - Eksplosjonsfare ved fejlagtig håndtering. Udskiftning må kun ske
med batteri av samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.
VAROITUS! Paristo voi räfähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan
laitevalmistajan suosittelemaan tyyppin. Hävitä käytetty paristovalmistajan ohjeiden mukaisesti.
WARNING! Explosionsfar vid felaktigt batteribyte. Anväd samma batterityp eller en ekvivalent
typ som rekommendars av apparatillverkaren. Kassera använt batteri enlight fabrikantens
istructions.
ACHTUNG! Dieses Produkt enthält eine Lithium-Batterie. Bei nicht korrektem Austausch besteht
Explosionsgefahr. Verwenden Sie zum Austausch ausschließlich das Modell Maxell CR2032.
Achten Sie beim Austausch unbedingt auf die richtige Polarität. Entsorgen Sie die alte Batterie
nach den Bestimmungen des Herstellers der Batterie.
Inhalte dieser Anleitung können jederzeit geändert werden, ohne gesondert darüber zu
informieren. Aufgrund von System-Optimierungen und -Erweiterungen im Laufe der
Produktionszeit ist es möglich, dass einige Teile dieser Anleitung nicht mit dem Bediensystem
Ihres Instrumentes übereinstimmen. Die in dieser Anleitung enthaltenen Beschreibungen
ersetzen alle früheren Anleitungsversionen.
FCC RULES
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital Device, persuant to Part 15 if the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio comunications.
However, there is no guarantee that the interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determinated by turning the equipment off and on, the user is encuraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-
Consult the dealer or an experienced Radio/Tv technician for help.
The user is cautioned that any changes or modification not expressly approved by the party
responsable for compliance could void the user's authority opearate the equipment.