Operation - Renkforce 2177900 Bedienungsanleitung

Operating instructions
USB-SoundBox 7.1
Item no. 2177900
Intended use
The product is designed for connection to a USB port on a computer and it serves as an
external sound card. Power is supplied via the USB port.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged.
In addition, improper use can cause hazards such as short circuiting, fire etc. Read the
instructions carefully and keep them. Make this product available to third parties only together
with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• USB SoundBox
• SPDIF cable (80cm)
• USB power cable (80cm)
Latest operating instructions
Download the latest operating instructions via the link www.conrad.com/downloads or scan the
QR code shown. Follow the instructions on the website.
Explanation of symbols
An exclamation mark in a triangle indicates important instructions in this operating
manual that absolutely have to be observed.
The arrow symbol indicates specific tips and advice on operation.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• When laying out the USB power cable, make sure that it is not damaged by sharp
edges.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
• CD
• Operating instructions
Operating controls
3 4 5 67
1
2
11
12 13
1 Microphone input (1), 3.5mm jack plug
2 Microphone input (2), 3.5mm jack plug
3 Button for "REC-Mute" (muting during microphone/SPDIF-IN recording)
4 LED for "REC-Mute" (the LED lights up when microphone/SPDIF-IN recording is muted)
5 Button for "Play-Mute" (muting during playback)
6 Button for turning up the playback volume
7 Power LED
8 Button for turning down the playback volume
9 Optical signal input (SPDIF-IN)
10 Optical signal output (SPDIF-OUT)
11 USB port (connect to a USB2.0 port on a PC or to a USB hub with appropriate power adapter)
12 Line input (LINE IN, 3.5mm jack plug)
13 Headphone output (Mic-In, 3.5mm jack plug)
14 Output FRONT L/R for front loudspeakers (3.5mm jack plug)
15 Output SIDE L/R for surround loudspeakers
16 Output REAR L/R for back loudspeakers
17 Output C/SUB for centre and subwoofer loudspeakers
Installation of the driver and connection
• Switch your computer on and wait until the operating system has finished booting.
• Place the CD included in the delivery in an appropriate drive on your computer. If the
installation program does not start automatically, open the CD, for example, using the
Windows File Manager and start the installation program contained on the CD.
®
• The software will then ask you to connect the USB SoundBox to the computer.
• Connect it using the USB cable enclosed to a free USB2.0 port on your computer or to a USB
hub on a USB hub with power adapter.
The USB SoundBox is a so-called high-power USB device and thus requires a
current exceeding 100mA. This means that the USB SoundBox will normally not
work when it is connected to a USB hub without a power adapter!
• The driver and software installation continues.
• The operating system may need to be restarted, after completing the installation!
• If your computer already has a sound card (e.g. Onboard Sound on the Motherboard), you
can switch between the installed sound card and the HD Sound Box in the Windows
Panel.
Normally, after connection to the computer, the HD SoundBox is the sound card that
is preferred.

Operation

• The volume of the audio playback can be decreased using the "
with the " " button (7).
• The audio playback is muted using the "
" (3) button mutes any microphone/SPDIF-IN that may connected ("REC-Mute"). The
• The "
LED (4) lights up.
8
OUT
14 15 16 17
" button (8) or increased
" (5) button ("PLAY-Mute").
9
10
Control
®