Operation - Renkforce M.A.R.L.I.S. Bedienungsanleitung

• Connect your mobile phone to the PA speaker set.
• After successful pairing, the indicator next to the BT button (5) lights up continuously.
• If pairing was not successful, try repeating the process. The PA speaker set may have to be deleted in your mobile
phone first (see mobile phone instructions).
Only one Bluetooth
connection already, this connections must be interrupted first. This is done via the menu of your mobile
phone.
If the mobile phone with which there is an active connection is switched off or removed from the range, the
connection is interrupted. The display next to the BT button (5) then goes out. When switching on again
or when the mobile phone returns into the PA speaker set range again, the connection is automatically
re-established. The display next to the button BT (5) lights up permanently again. To permit this automatic
establishment of connection, this function may have to be activated at the mobile phone (read about this in
your mobile phone's instructions).
If the PA speaker set has been switched off, the pairing process must be repeated after switching on.

10. Operation

Only put the device into operation when you have become familiar with its features and these operating
instructions. Check again that all connections are correct. Do not put the product into operation if it is
damaged.
The PA speaker set should always be the last to be turned on and the first to be turned off. This way you
can prevent any undesired noise (which typically occurs when switching off a mixer) that may damage the
PA speaker set.
Make sure that the connected devices are not overloaded. Playback must never be distorted. If distorted
music signals can be heard although the volume was not set too high, switch off the PA speaker set
immediately and check the connection. If the connection is correct, please contact a specialist.
The device must only be operated by persons familiar with the operating instructions and observing them.
Keep other persons and children away from the device.
• Turn the controls MAIN LEVEL (7) and SUB LEVEL (10) down completely (to the left).
• Turn the controllers MP3 / BT (1), LINE (2) and MIC (3) to the middle position.
• Turn the PA speaker set on with the POWER switch (15).
• Set the mixer volume to approx. 75% of the maximum volume or the maximum undistorted level (visible for devices
with level indicator at the "0 dB mark).
device at a time can be coupled with the PA speaker set. If there is an active Bluetooth
® ®
31