Noise/Vibration Information; Auxiliary Handle - Bosch PBH 220 RE Originalbetriebsanleitung

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 86 dB(A);
Sound power level 97 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Hammer drilling into concrete: Vibration emis-
sion value a =14 m/s
h
Chiselling: Vibration emission value a
Uncertainty K=1,5 m/s
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Bosch Power Tools
2
, Uncertainty K=1,5 m/s
=9 m/s
h
2
.
Assembly
Before any work on the machine itself, pull
the mains plug.

Auxiliary Handle

Operate your machine only with the auxilia-
ry handle 11.
Rotating the Auxiliary Handle (see figure A)
The auxiliary handle 11 can be set to any posi-
tion for a secure and low-fatigue working pos-
ture.
2
,
2
,
– Turn the wing bolt for adjustment of the aux-
iliary handle 18 in anticlockwise direction
and set the auxiliary handle 11 to the re-
quired position. Then tighten the wing bolt
18 again in clockwise direction.
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the
depth stop 9.
– Loosen the wing bolt for depth stop adjust-
ment 19.
– Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drill-
ing depth X.
– Retighten the wing bolt for the depth stop
adjustment 19 again.
Selecting Drill Chucks and Tools
For hammer drilling and chiselling, SDS-plus
tools are required that are inserted in the SDS-
plus drill chuck.
For drilling without impact in wood, metal, ce-
ramic and plastic as well as for screwdriving,
use the quick change keyless chuck and drilling
tools without SDS-plus.
English | 21
1 619 929 804 | (16.10.07)