Introduction; Device Description; Scope Of Delivery; Proper Use - Scheppach BTS700 Original Bedienungsanleitung

1.

Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual package with the machine at
all times and store it in a plastic cover to protect it from dirt
and moisture. They must be read and carefully observed
by all operating personnel before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (fig. 1-2)
1. Grinding belt
2. Sanding belt table
3. Sanding belt guard
4. Sanding belt (velcro fastener)
5. Adjustable sanding table
6. Sanding table adjustment
7. On/off switch
8. Engine
9. Sanding belt adjustment screw
10. Suction port for disc sanders
11. Suction port for belt sanders
12. Transverse cutting gauge
3. Scope of delivery (fig. 3)
• Belt and disc sander (a)
• Sanding belt table (2)
• Suction port for belt sanders (10)
• Transverse cutting gauge (12)
• Adjustable sanding table (5)
• Clamping screw M6 2x (b)
• Washer Ø6 2x (c)
• Phillips screw M4x10 3x (d)
• Washer Ø4 3x (e)
• Clamping lever M8 1x (f)
• Washer Ø8 1x (g)
• Operating manual

4. Proper use

The purpose of the belt and disc sander is to sand all
types of wood, depending on the size of the machine.
The machine may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
An element of the intended use is also the observance of
the safety instructions, as well as the assembly instruc-
tions and operating information in the operating manual.
www.scheppach.com GB | 21