Built-In Receiver; Built-In Receiver / Bluetooth - Skandika Centaurus 2.0 Anleitung

BUILT-IN RECEIVER

The computer is equipped with a built-in receiver, which can receive the pulse signals measured by a compatible
(uncoded/5 kHz, e.g. Skandika chest belt) chest belt wirelessly.
So you can decide, if you want to measure your pulse frequency by the hand sensors or by the chest belt. A chest belt
would enable you to exercise without the need to grasp the hand sensors all the time. Make sure, the correct battery is
inserted into the chest belt if you want to use this feature.
You may adjust the strap to a comfortable length. However, the electrodes must have contact with your skin in order to
measure your heart rate correctly. It may last up to one minute before a correct display can be seen.
Always pay attention to the instruction manual of the chest belt device. In case you grip the hand sensors and wear a chest
belt at the same time, the device will prefer the signal from the hand sensors.
The computer can be connected via Bluetooth (frequency: 2.4 GHz) to communicate with the apps iConsole+
or KinoMap.
ICONSOLE+
Activate Bluetooth on your mobile device, download the app „iConsole+" an install on your iOS- or
Android device. You may use the app search function of your mobile device or the following QR code to
find the app:
System requirements:
Android 5.0 or newer with Bluetooth 4.0
iOS 10 or newer with Bluetooth 4.0
BFor Android devices, „unknown sources" need to be accepted in the device security settings („Settings
-> Device security").
After starting the app, the connection with the training device need to be established via Bluetooth -
therefore select „Quick Start", „Interval", „Map":
Once console is connected to smart device via Bluetooth , the console will power off.
35

BUILT-IN RECEIVER / BLUETOOTH