Error Messages - Skandika Centaurus 2.0 Anleitung

ERROR MESSAGES

"---- " " ----"
E-1
E-4
NOTES
1) This computer has an automatic on/off function so that it switches on when the pedals move or when any button is
pressed, and turns into stand-by mode automatically if no signal has been received for approx. 4 minutes.
2) In case of any abnormal functions, disconnect the device from power source and reconnect after some minutes
ERROR MESSAGES
34
means, that the contact to the handpulse sensors was not
sufficiently for a measurement. The reason for this can be
that you have not grasped the two sensors correctly. Start a
new measurement with correctly placed hands!
means, that no heart rate signal has been detected.
appears, if the fat % or BMI values are too low (<5) or too
high (> 50).