Remote Control - STEINEL US 360 COM1 Handbuch

COM 2
Potentiometer g
Stay-ON time for switching output 2 HVAC
• Setting 1 min. – 2 hr.
• Turned fully clockwise: max
• Turned fully anti-clockwise: min
Potentiometer h
Switch-ON delay for switching output 2 HVAC
• Setting 0 sec. – 10 min. Turning the potentiometer to the
• Turned fully clockwise: "Surveillance" setting reduces the
Room surveillance sensitivity of the "Presence"
• Turned fully anticlockwise: switching output.
0 sec. (OFF) The contact only closes on detect-
ing a pronounced movement, sig-
nalising with a high degree of cer-
tainty that persons are present.
Potentiometer o
Basic light level (DIM version)
Provides basic illumination for the light intensity (constant-lighting
selected stay-ON time when ambi- controller OFF) or adjusts to the
ent light falls below the selected preselected light level (con-
light-level threshold that is set. stant-lighting controller ON). When
This can be dimmed to 10% of no movement is being detected,
maximum light intensity. As soon the detector dims back to basic
as a person enters the scene, the light level after the stay-ON time
detector switches either to 100% expires. This is switched OFF when
Reach adjustment
Potentiometer i
The reach required (response Turned fully anticlockwise =
threshold) is infinitely variable. minimum reach
< US 360 / DualTech
Turned fully clockwise
at least 2 x 2 m - 6 x 6 m
(factory setting) = maximum reach
presence
< Single US / Dual US
at least 3 x 3 m - 10 x 3 m
in each direction
The stay-ON time remains active.
The switch-ON delay is inactivated.
stay-ON time (1 min. – 30 min.) has
expired or the daylight component
is sufficient to exceed the selected
level of brightness. In the ON set-
ting, the detector switches basic
light level ON and OFF as soon as
the level of light falls below the
light-level threshold.
- 26 -
Parallel-connected configurations
When using several detectors, they As many as 10 sensors can be
must be connected to the same connected in parallel.
phase!

Master/master
1 4.
1
A parallel-connected configuration ness it measures. Delay times and
also permits the use of several light-level thresholds are selected
masters. In this case, each master at each master as required. The
operates the lighting group in ac- switched load is spread among the
cordance with the level of bright- individual masters. Presence is still

Master/slave
1 4.
2
The master/slave configuration vailing in the room is only evaluat-
permits detection of movement in ed at the master. The slaves report
large-type rooms or spaces (load movements detected to the mas-
connected = master, no load = ter. Lighting or HVAC is switched
slave). The level of brightness pre- ON and OFF by the master only.

1 4. Two detectors linked with an Old building / building
3
external stairwell lighting modernisation
timer

14. Detector as stairwell lighting
4
timer

DIM detector
1 4.
5

*
This external button cable is
not intended to serve as a
neutral conductor connec-
tion for loads (see page 6/7).

Remote control

Using the remote control (option- Note: The pulse mode cannot be
al), functions can be conveniently overridden by the remote control.
activated from the floor. Switch pulse mode OFF manually.
detected collectively by all detec-
tors. The presence output can be
picked off from any master.
External light source activated by
button. No twilight mode, day
mode only.
Presence Control remote control
unit: EAN no: 4007841 559410
- 27 -