Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Suction hose
32
Spray / suction hose
33
Quick Start Guide
34
Wastewater container, removable
35
Wastewater container carrying handle
36
Cover seal
37
Fluff filter
38
Fresh water filter
39
Table of nozzle mouthpieces
Colour Part
Flow vol-
number
ume
Yellow
6.415-
2.0 l/min
165.0
Green
6.415-
1.2 l/min
105.0
Brown
6.415-
1.0 l/min
166.0
Blue
6.415-
1.0 l/min
928.0
Red
6.415-
0.55 l/min Uphol-
097.0
Initial startup
1. Check hoses for damage before each startup.
Installing accessories
1. Adv only: Fit the suction pipe onto the floor nozzle
and hand-tighten the union nut on the floor nozzle.
2. Adv only: If necessary, slide the handle onto the suc-
tion pipe and hand-tighten in the desired position.
3. Adv only: Fit the angle piece onto the suction pipe
and hand-tighten the union nut on the angle piece.
4. Connect the suction hose to the suction hose con-
nection on the device. Insert the spray hose cou-
pling into the spray hose connection on the device
and latch into place.
5. Connect the suction hose to the manual nozzle or
the elbow. Connect the spray hose coupling to the
manual nozzle or angle piece and latch into place.
Mixing the cleaning solution
DANGER
Danger from detergents
Risk of injury and damage
Observe all instructions that are included with the deter-
gents used.
Note
Warm water (maximum 50 °C) increases the cleaning
effect. Check the temperature resistance of the surface
to be cleaned.
Note
Use detergents sparingly to conserve the environment.
1. Mix fresh water and detergent in a clean container
(concentration as specified for the detergent). Dis-
solve the detergent in the water.
Applica-
Approved
tion
for device
Floor noz-
Puzzi 10/2
zle
Floor noz-
Puzzi 9/1 Bp
zle
Floor noz-
Puzzi 8/1,
zle
Puzzi 10/1
Uphol-
Puzzi 8/1,
stery noz-
Puzzi 10/1,
zle
Puzzi 10/2,
Puzzi 30/4
Puzzi 9/1 Bp
stery noz-
zle, short
English
Filling the fresh water tank
1. Pour the cleaning solution into the fresh water tank.
The filling level must not exceed the "MAX" mark.
Defoaming agent
Note
Foam is generated in the wastewater container when
cleaning previously shampooed carpets. Foaming can
be prevented by adding defoaming agents.
1. Add defoaming agent (special accessory) to the
wastewater container.
Inserting the battery pack
1. Slide the battery pack into the battery holder and
lock it in place.
Charging the battery pack
Note
Read the operating instructions of the charger, especial-
ly the safety instructions!
Note
Read the operating instructions of the battery pack, es-
pecially the safety instructions!
Note
The battery pack is partially charged on delivery.
Charge before use and when necessary.
Note
The battery pack can only be charged when it is re-
moved.
1. Press the unlocking button and remove the battery
pack.
2. Charge the battery pack according to the operating
instructions of the charger and battery pack.
Operation
Switching on the device
1. Press the spray switch to switch on the spray pump.
The spray LED lights up.
2. Press the suction switch to switch on the suction tur-
bine. The suction LED lights up.
Cleaning mode
ATTENTION
Danger from cleaning solution
Risk of damage
Before using the device, check the object to be cleaned
for colour fastness and water resistance in an inconspic-
uous place.
1. Remove loose dirt from the object to be cleaned.
2. Press the lever on the manual nozzle or angle piece
to spray the cleaning solution.
3. Run over the surface to be cleaned in overlapping
paths. Pull the nozzle backwards (do not push).
4. Adv only: When work is interrupted, the floor nozzle
can placed in the device carrying handle.
5. When changing the nozzle, the manual nozzle can
be inserted into the holder for accessories.
Switching off the device
1. Switch off the spray switch and the suction switch.
The LEDs extinguish.
Empty the wastewater container
1. Switch off the suction switch and the spray switch
when the wastewater container is full.
2. Remove the cover.
3. Remove the wastewater container from the device
and empty it.
11
Werbung
Kapitel
