Operation End-Stop; Emergency Release; Adjustment Of Stop Ends - V2 AXIL Serie Bedienungsanleitung

OPERATION END-STOP

Versions WITHOUT electrical end-stop
For the end-stop operation, proceed as follows:
• Bring the shutter in position of maximum opening,
then position the mechanical stop A, and shot effect,
against the crosshead nut.
• Block the mechanical stop by fastening the bolt with a
13mm key.
• Bring the shutter in position of maximum closing,
then position the mechanical stop B, and shot effect,
against the crosshead nut.
• Block the mechanical stop by fastening the bolt with a
13mm key.
Versions WITH electrical end-stop
The electrical end-stop (already wired inside the motor)
interrupts the feeding on the motor preventing
unnecessary stress and overheating.
For the end-stop operation proceed as follows:
• Remove the front crankcase of the motor and loosen
the assembly nut that holds the electrical end-stop
• Bring the shutter in position of maximum opening and
position the electrical end-stop so that the switch
engages.
• Close the assembly nut that holds the electrical
end-stop
• Insert the front Carter (casing), close the feed screw
and or insert plugs
• Position the mechanical stop so that the run is
immediately blocked after the engaging of the switch.
• Block the mechanical stop by fixing the bolt with a
13mm key.

EMERGENCY RELEASE

In case of lack of electrical power, or loss of power, bypassing
the motor can unblock the gate:
1. Open the closing cover J located on the front side of the
motor
2. Insert key K in the lock, turn it clockwise and completely open
the plastic access flap
3. Insert key L in the hole and rotate clockwise until end-stop
In order to restore the automation proceed as follows:
1. Turn the key L in counter-clockwise sense until end-stop and
remove it
2. Close the access flap and turn the key K in counter-clockwise
sense
3. Cover the lock with the access flap J
11