Beko HCA62641BH Bedienungsanleitung Seite 15

5 Installation of appliance
Install the chimney to the chimney fastening plate
that is secured to the wall from its upper outer
edges (Figure 7).
(Figure 7)
5.6 Installation of air baffle
While using with the carbon filter, air baffle is pro-
vided with your appliance with the aim of re-re-
leasing the air which is cleaned with carbon fil-
ter from the perforated located on the chimney.
Assemble the air baffle as below.
(Figure 8)
There is a tab in the middle of the chimney con-
nection plate. Place the middle point of this tab on
the line that is drawn perpendicular to the wall.
Cooker Hood / User Manual
Align horizontally and mark the holes where the
connection plate will be mounted via a pen (Figure
8/A, B).
Drill the marked points with Ø6mm drill and in-
sert two Ø6mm plastic dowels in the drilled holes
(Figure 8/A, B).
Fix the chimney connection plate to the wall with
3.9x22 screws (Figure 8/A, B).
For the assembly air baffle, drill points C, D, E, F
with a Ø6mm drill bit and tap the Ø6mm plastic
dowels (Figure 8).
Assemble cooker hood's body (Figure 4).
(Figure 9)
1. Flap Pin Socket
2. Flap Pin
Attach the flue flaps to the plastic flue adapter in
the package content as follows. Insert the plastic
pin (Figure 9/area no. 2) on the pin socket on the
motor exhaust (Figure 9/area no.1). Then bend the
flap lightly to insert the other pin on the flap and
insert the other pin to its socket (Figure 9).
15 / EN