Beko HCA62641BH Bedienungsanleitung Seite 14

5 Installation of appliance
(Figure 4)
Hold the cooker hood by its body and place it on
the mounting screws on the wall and tighten the
screws (Figure 4).
Secure the cooker hood with two 4.8x50 screws to
the wall through the mounting hole on the interior
of the appliance (Figure 4).
5.4 Connecting to Chimney
(Figure 5)
1. Flap Pin Socket
2. Flap Pin
Insert the plastic pin (Figure 5/area no. 2) on the
pin socket on the motor exhaust (Figure 5/area
no.1). Then bend the flap lightly to insert the other
pin on the flap and insert the other pin to its socket
(Figure 5).
If you are going to use the Ø 120/150 mm plastic
Chimney adapter, connect one end of the pipe to
14 / EN
this adapter, if you are not going to use it, to the
direct output on the product. Connect the other
end of the pipe to your chimney. Check that these
two connections are tight enough so they will not
come out when the appliance runs on full pow-
er. Ensure that the flaps inside the chimney work
when tightened with clamp. Connect the chimney
connection duct outside the adapter (Figure 6/a).
If the connection duct is fitted inside the adapter,
suction of air shall not occur as the Chimney flap
that prevents the return of air will remain closed
(Figure 6/b). The length of the pipe connection as
well as the number of elbows must be as mini-
mum as possible.
A : Chimney exit pipe
B : Chimney Clamps
C: Plastic Chimney
The valves are closed then the appliance is not
operating and prevent possible outside odour and
dust from entering inside.
(a)
Ok
(Figure 6)
5.5 Installation of the Hood to the
chimney
Make the electrical connection of your hood before
starting the installation of the chimney. Slip the
chimney plates around the body. Screw the chim-
ney to the chimney fastening plates available on
the motor cabin. (Figure 7).
Cooker Hood / User Manual
(b)
Not Ok