Cleaning And Care - Klarstein AROMATICA TASTE 6 Bedienungsanleitung

7. Grinding and brewing
When the on-bean or tow-bean symbol is lit on the display, the machine is in grinding
and brewing mode. You can set the coffee strength with the grinding and brewing
button. Press the cup button to set the number of cups.
Press the On/off button to start the process. The machine fi rst grinds the beans and then
brews the powder. When the water has completely drained from the tank, the machine
switches to warm mode.
8. Keep warm mode
When the brewing process is complete (after max. 40 minutes), the appliance goes into
keep warm mode. The operating light is on and the appliance indicates this by humming
three times. When the warm-keeping mode ends, the machine goes into standby mode.
The unit hums three times and the operating lamp goes out.
9. Decalcifi cation mode
After 70 brewing cycles, the appliance reminds you to decalcify by lighting up the CALC
display. The machine counts one warm-keeping operation as one brewing cycle.
Decalcify the machine with a commercially available decalcifi er or a water/vinegar
mixture. Fill the water tank with the mixture and run the mixture through the machine
once. Then fi ll the water tank with fresh, clean water up to the MAX mark and allow the
water to run through as well.
Press the CALC button in standby. The lamp on the CALC button fl ashes and the display
shows the symbol . Press the CALC key to stop the decalcifi cation after 10 minutes.
The light of the CALC key goes out. Decalcifi cation is fi nished.
Abnormal indication: Buzzer beeps twice and machine will enter the standby mode
when the gate above the fi lter holder is closed or opened abnormally.

CLEANING AND CARE

• Clean the machine after each use.
• Always unplug the power cord before cleaning.
• Never immerse the housing in water or other liquids.
• Disconnect the coffee machine from the power supply and allow it to cool
completely before cleaning.
• Clean the housing surface with a soft, damp cloth.
• Do not clean the hot plate with abrasive cleaner or steel wool.
• Clean the glass carafe and funnel with water and dry both parts carefully.
• Remove the spray arm and clean it as well.
EN
17