Factory Settings - Balluff BOS 50K-PI-RD11-S4 Kurzanleitung

Photoelectric Sensors
Red light diffuse reflective energetic BOS 50K-...-PI11-S4 with IO-Link
Service data
Events
Event Meaning
Code
0x4210 Over tempe-
rature
0x5111 Low voltage
0x6350 Parameter
changed
0x8CA1 Timeout
Dynamic
Teach
0xFF91 DS Upload
Request

Factory settings

At delivery and after System command "Restore factory
settings" the sensor is factory-set:
Parameters of Binary Data Channel
All BDC are operated in Single Point Mode with Switch-
point logic N.O.
All Setpoint values are reset to its factory values.
BDC1
Setpoint MAX_SP*
SP1
Setpoint
SP2
Switch- Single Point Single Point
point mode Mode
Switch- N.O.
point logic
*MAX_SP corresponds to: Switching distance ≈ 3500 mm with
90% gray card
19
Mode Type
appears/disappears Warning
appears/disappears Warning
single shot Notifica-
single shot Notifica-
single shot Notifica-
BDC2 BDC3 BDC4
MAX_ MAX_ MAX_
SP+200 SP+200 SP+200
MAX_SP MAX_SP MAX_SP
Single Point Single Point
Mode Mode Mode
N.O. N.O. N.O.
Instance Device Status
Application Out-of-Specification
Application Out-of-Specification
Application
tion
Application
tion
Application
tion
Parameters of Teach Channel
Index (dec) Parameter
0x003A (58) Teach-In
Channel
0x003B (59) Teach-In
Other Parameters
Index (dec) Parameter
0x000C
(12) Access
0x0018 Application
(24) Specific Tag
Remark
T ≈ 50 °C (U
A
U < 18V
B
After a failed plausibility
check for SP1 and SP2
the corresponding BDC
is reset to its factory
settings.
Dynamic Teach-In
> 10 min active
After local Parameteriza-
tion with Teach Button
(Teach-In or setting
output function) and
System command
„ParamDownloadStore"
Factory Remark
setting
0x00 Standard BDC =
0x00 Teach State =
Status
Factory Remark
setting
Device 0x0000 Data Storage
Locks Teach Button
unlocked
„Sensors
World-
wide"
=24V)
B
BDC1
IDLE
and