Electrical Connection - Maico AKE 150 Montage- Und Betriebsanleitung

8. Insert housing into wall breakthrough/wall
sleeve and secure with two screws. Do not in-
sert the housing such that it is twisted or
crushed. Make sure you use mounting mater-
ial which is sized for the purpose.
9. Lay sensor connection cable in the provided
recesses (I, II) and plug it [A] into the elec-
tronic circuit board.

8.5 Electrical connection

NOTICE Risk of damage to unit in the event of
short-circuits.
Insulate PE conductor and individual cable cores
that are not required.
Do not touch electric components.
1. Only lay single cable cores in the fan. To do
this, remove power cable sheathing over a
length of 110 mm. Strip single cable cores to 9
to 10 mm.
13 Spring clip
14 Connection wiring diagram
2. Connect power cable to the spring clip → Wir-
ing diagrams [} 36].
3. Check position of cable grommet. It must be
well sealed.
8 Installation and commissioning
8.6 Final mounting
NOTICE Danger of short-circuits and damage
to the unit. Humidity will penetrate if electron-
ics cover is not fitted correctly.
Press electronics cover firmly onto housing such
that it is sealed and flush all the way around.
When doing so, do not press setting buttons.
15 Setting button for start delay
16 Setting button for overrun time
1. Push the electronic cover on the housing cut-
outs I, II and III onto the 3 locking tabs, until
the tabs engage. In addition, press the elec-
tronics cover firmly on to the housing at the
points indicated by the word "PRESS".
2. Insert the supplied internal climate sensor cor-
rectly (arrow) in the connector sockets.
H and KH: Do not touch/push on the mem-
brane on the flat side of the sensor wall,
otherwise it will be damaged.
3. Fit cover.
8.7 Commissioning
1. Switch the mains fuse on.
2. Run function test.
3. Save reference humidity by pushing button 1.
21