SmartGyro RAPTOR Bedienungsanleitung Seite 14

EN
Start the march:
1 Power button
With the skateboard off, press the on / off button for 3 seconds and
the scooter will turn on.
2. Operating modes
With the skate on press the "+ and -" button to switch between the 3
operating levels.
3. Brake control
The hydraulic brake cuts off the power to the motor. When you need
to brake or stop the device, you can do so by using the brake levers
that actuate the brake discs.
4. If you want to use the turn signals, press the switch located on the
handlebar to one side or the other.
Battery and Charger:
Each smartGyro is equipped with a lithium battery and its charger, it
also has its own serial number. Do not replace the battery or its
charger, it could be dangerous.
Lithium battery
Please fully charge the battery before using your smartGyro Raptor.
Charge the battery when its level is in the middle of the power bar to
avoid influencing your driving.
Charger
The charger's overcharge protection function will automatically stop
the charging process when the battery is 100% full.
Instructions for loading:
1. Connect the plug of the charger to the mains.
2. Important: Plug the charger into a 100V-240V outlet.
3. Red light: charging process. Green light: charging process comple-
ted. Please always store the charger in a dry and ventilated environ-
ment.
13