Heating Step Adjustment; Temperature-Setting; Oscillation Function; Timer-Setting - Silvercrest SKWH 2000 A2 Bedienungs- Und Sicherheitshinweise

7.2 Heating step adjustment

By pressing the heating level button
you can adjust the desired heating level.
By each pressing the button
switch to the next heating level. Depend-
ing on the selected heating level, you will
see the respective value on the display.
Press 1x: 1 heating level (1000 W)
Press 2x: 2 heating level (2000 W)
Press 3x: Fan

7.3 Temperature-Setting

When setting the temperature, please
note that the device will not heat, if the
desired temperature is not higher than the
ambient temperature. To enable heating,
the set temperature needs to be at least
1°C higher than the ambient temperature.
The latter is automatically displayed when
the device is turned on. After successful
temperature setting, the symbol appe-
ars on the display. The fan continues for
30 seconds before it switches off.
Switch on the device (see Starting Up).
Press the temperature button
the temperature.
Press the plus button 8 to increase the temper-
ature. Press the minus button 7 to reduce the
temperature (between 18 and 45°C).
After setting the desired temperature, press the
OK button 5 or simply wait for 5 seconds with-
out making any entries.
Please note:
You can cancel the input any time by pressing the
cancel button 6 .

7.4 Oscillation Function

,
11
, you will
11

7.5 Timer-Setting

Please note: As long as a week timer is activated,
the turn-off timer cannot be used (see Chapter
"Deactivation of the Weeks Timer").
With the aid of the timer, you can select the turn-off
time in hour increments. Then the wall-mounted cera-
mic fan heater will switch off automatically.
once to adjust
10
By repeatedly pressing the timer button 4 the timer
will be adjusted in 1-hour increments:
0H – 1H – 2H – 3H – 4H – 5H – 6H – 7H – 8H
Example: If the device should automatically switch
off after 4 hours, press the timer button 4 until you
see „4H" on the display.
To turn the device's oscillation function
on or off, press the oscillation button
2 . If the oscillation function is enabled
successfully, it will be shown on the dis-
play. The oscillation function means
that the blown air is distributed from the
top to the bottom.
The purpose of the timer is to automatically
turn off the ceramic fan heater.
Turn the device ON (see Starting Up). Press the
timer button 4 repeatedly until you reach the
desired number of hours.
Wait about 5 seconds. The information is auto-
matically transferred. Then the device will be
automatically turned off in 4 hours.
If you want to make sure that the timer entry has
been transferred, press the timer button 4 once
more. Then „4H" or your entry will appear in
the display.
GB/IE/NI/CY/MT 19