Herunterladen Inhalt Inhalt Diese Seite drucken

Unpacking, Setting Up And Inserting The Battery; Setting Up The Appliance - Silvercrest SHLF 2000 A1 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SHLF 2000 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 67
RP53439 HL mit FB LB4 Seite 7 Dienstag, 13. Juli 2010 3:13 15

4. Unpacking, setting up and inserting the battery

4.1 Setting up the appliance

Note! As the appliance and heating coils
are supplied with a thin film of grease, there
might be a small amount of smoke and
odour the first time the appliance is used.
This is not harmful and will stop after a short
while. Please ensure meanwhile that there is
sufficient ventilation.
1. Unpack
the
packaging.
2. Remove the transport packaging.
Note: There is a piece of corrugated
cardboard
positioned
appliance and the base 9 . This must also
be removed.
3. Check that the appliance shows no signs
of damage.
Warning! Ensure that there is suf-
ficient distance from the wall, fix-
tures and other appliances. The
distance must be at least 1.5 m to
exclude the risk of fire.
4. Select a location that complies with the
safety information (see "3. Safety infor-
mation" on page 4).
5. Select a location where the flow of hot
air is not directly aimed at people, ani-
mals or plants.
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note: The appliance consumes up to
10 amperes of current. If you have plug-
ged other power consumers into the
same circuit, check that the maximum
load for the installed fuse is not excee-
ded, as otherwise the fuse will trip.
SHLF 2000 A1
appliance
from
the
between
the
4.2 Inserting the battery
If the appliance is new or the battery in the
remote control is flat, a new type CR2032
battery must be inserted.
1. Press
the
catch
towards
the
middle and pull
out
the
battery
compartment.
2. Remove the old
battery if present.
Note: Please observe the instructions for
disposal (see "8.2 Disposable/recharge-
able batteries" on page 11).
3. Insert a new battery.
Note: Ensure the correct polarity (+/–)
when inserting the battery. The correct
polarity is marked on the battery com-
partment.
4. Slide the battery compartment back in
again.
7

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis