Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Display Messages - HAPRO COLLAGEN SUN 26/5 Anleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10

Operation

Operation
Start
A
Stand-alone mode:
By depressing start once the "+ and –" buttons can be used to
set the tanning time . Pressing for a second time will start the
unit .
Coin mode:
The unit can be started automatically by the external timer or
the coin automat . The start button can be used only when the
unit has to be restarted from "pause" .
Stop
B
Stand-alone mode:
Pressing stop once will cause the unit to "pause" . The lights will
go out but the ventilation will continue to run .
Pressing stop twice will initiate a mandatory after-cooling phase
of 3 minutes . The unit cannot be started during these 3 min-
utes .
Coin mode:
Pressing stop once will cause the unit to "pause" . The lights will
go out but the ventilation will continue to run .
The unit will not respond to pressing stop several times . The ex-
ternal timer or coin automat will switch the unit off . Switching
off will initiate a mandatory after-cooling phase of 3 minutes .
The unit cannot be started during these 3 minutes .
Illustration after-cooling
Stand-alone mode:
C
a . Reduce tanning time
b . Reduce body cooler speed
Coin mode:
a . Reduce body cooler speed
Stand-alone mode:
D
a . Increase tanning time
b . Increase body cooler speed
Coin mode:
a . Increase body cooler speed
Face
E
Switch the face tanner on and off
Fan
F
Switch the body cooler on and off
6
A
B C
General:
The unit is generally set for use without external timer or coin automat
(stand-alone mode) . When the unit has to operate in combination with an
external timer or a coin automat (coin mode), the internal time should be
set to 0 minutes as per procedure below .
depress continuously for 10 seconds
after 10 seconds depress the "-" button and contin
ue to press until the display indicates "00"
press once and the unit will bleep in response .
Note: The maximum tanning session is restricted
to 30 minutes .

Display messages:

Overrule error (Switch print and/or display print defect)
Filter glass defect (Filter glass of the face tanner is broken
or glass protection is defective)
Communication error (No communication between
switch print and display print)
Note: When you receive one of the above error messages on
your LCD display, you should stop using the unit and remove
the plug from the socket. Contact your dealer.
This symbol will appear on the lcd display after 500 tan-
ning hours . It is preferable after 500 tanning hours to re-
place the lamps with new . After replacing the lamps reset
the lamp hour counter .
Note: On the label on the back of the unit the lamps are
stipulated that are suitable for your unit.
Sundry:
Hour counter lamps x 10
Reset hour counter lamps
Hour counter sun bed x10
D
E
F

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis