Cleaning And Maintenance; Troubleshooting - Kampa Watergate Canopy Montage- Und Bedienungsanleitung

• Peg the guy lines so that the canopy is under ten-
sion without distorting the shape.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners to
adjust.
Set up the canopy as follows:
1. To protect the canopy from dirt and damage,
lay down a groundsheet or footprint before
unpacking.
2. Unpack the canopy.
3. Separate and identify the different compo-
nents.
4. Proceed as shown to set up the canopy
(fig. 1, page 3 – fig. 8, page 5).
Dismantling the canopy
A
NOTICE! Material damage
Do not use force when dismantling the
canopy. Otherwise you might damage
any material.
1. Reverse the set up procedure.
2. Push the poles out of the sleeves, do not pull.
3. Ensure that all parts are clean before packing
in the carry bag.
4. If the canopy is wet or damp, dry fully as soon
as possible.

Cleaning and maintenance

A
NOTICE! Material damage
• Do not use sharp or hard objects or
cleaning agents for cleaning.
• Do not use alcohol based materials,
chemicals, soap and detergents for
cleaning.
• Remove bird droppings and tree resin
as soon as possible to avoid perma-
nent damage to the material.
1. If necessary, clean the product with clean
water and a soft brush.
2. Apply impregnation against water and UV
radiation before each trip.
8
Storing the canopy
I
NOTE
• Fully set up the canopy for cleaning.
• Choose a sunny day for cleaning to
1. Clean the canopy.
2. Air fully and ensure the canopy is totally dry
before packing away.
3. Store in a well ventilated dry place.

Troubleshooting

I
NOTE
• During first exposure to water there
• A fully equipped spare parts kit should
Problem
Water leak
Rip in the fabric
Shock cord connect-
ing the poles has
broken
Pole has broken
4445103459
ensure the material will dry thoroughly.
may be some moisture at the seams.
Through this moisture the threads will
swell and fill the holes that are created
in the sewing process.
include:
– Waterproofer
– Repair tape and repair solution
– Silicone spray for the zippers
– Spare pegs
Solution
➤ Check for leaky seams,
damaged tapings and
moist areas.
➤ If you cannot find any
leaks, see chapter "Con-
densation" on page 9.
➤ If you find any leaks, apply
seam sealant.
➤ Use repair tape to seal the
fabric.
➤ Have repairs carried out
by an authorized
specialist.
➤ Purchase a replacement
shock cord.
➤ Replace the shock cord.
➤ Use a metal peg as a
splint by taping it to the
broken pole.
➤ Purchase a new pole.