Matching The Sensor To The Selected T-Piece - IFM Electronic efector300 SA1004 Bedienungsanleitung

5. Matching the sensor to the selected T-piece

Apply the operating voltage.
1
Press briefly before the LED's
2
3
Press several times until the
selected pipe size is indicated.
4
Press briefly
(= acknowledgement).
here with label for T-piece QL 18-18-18
= LED lit in green
12
All manuals and user guides at all-guides.com
go out.
All LED's light and go off one
after the other.
QL18 QL22 QL28
The two LED's on the right are
lit in green (= unit is in the
programming pipe size mode).
The green LED's 1 to 3 indicate the
pipe size.
All LED's light and go off one
after the other.
Unit is then ready for operation.