Stihl FG 2 Gebrauchsanleitung Seite 22

English
1
Swing the filing frame upwards.
N
Loosen the knurled nut (1).
N
Lift the guide clear of the teeth and
N
turn it to exactly the same angle
setting on the opposite side.
Tighten down the knurled nut.
N
Turn the chain rest 180°, as
N
described under "Setting Up".
Reset the file.
N
Swing the filing frame down.
N
20
Position the round file between the
N
side plate and depth gauge of the
first cutter in the second row.
Sharpen the first cutter in the
N
second row.
A
Check the cutter length (A).
N
If it differs from the length of the master
cutter:
3
Move the stop (3) forwards or
N
backwards and resharpen.
Check the cutter length (A).
N
Repeat the procedure if necessary
N
until setting is correct,
Sharpen all cutters in the second
N
row using this setting.
Depth gauge
Select the filing gauge (special
N
accessory) that matches the chain
pitch.
Chain pitch Filing gauge
inch mm Part No.
1/4 6,35 1110 893 4000
3/8 P 9,32 1110 893 4000
0.325 8,25 1110 893 4000
3/8 9,32 1110 893 4000
0.404 10,26 1106 893 4000
1
Place the selected filing gauge (1)
N
on the chain.
Check height of depth gauge.
N
If the depth gauge projects above the
filing gauge, it has to be lowered.
35
30
Set the filing angle on the guide to
N
0°.
Pull the chain along the bar until the
N
depth gauge is under the file.
Fit triangular file (special accessory)
N
in place of the round file.
FG 2