Cleaning The Charger; Troubleshooting - Medtronic GUARDIAN 4 Bedienungsanleitung

4. Continue with the cleaning procedure. See Cleaning the transmitter, page 24 for details.

Cleaning the charger

This procedure is for general cleaning as required, based on physical appearance.
CAUTION: Do not immerse the charger in water or any other cleaning agent. The charger is
not waterproof. Water can damage the charger and cause the device to malfunction.
To clean the charger:
1. Wash hands thoroughly.
2. Use a damp cloth with mild cleaning solution, such as a dishwashing detergent, to clean any dirt
or foreign material from the outside of the charger. Never use organic solvents, such as paint
thinner or acetone, to clean the charger.
3. Place the charger on a clean, dry cloth and air dry for two to three minutes.
Bathing and swimming
After the transmitter and sensor are connected, they form a waterproof seal to a depth of 2.4 meters
(8 feet) for up to 30 minutes. Shower and swim without removing them.

Troubleshooting

The table shown contains troubleshooting information for the transmitter, charger, and tester. For
more information about troubleshooting, see the MiniMed 780G System User Guide.
33