Uninstalling The Heat Pump; Cleaning; Cleaning The Device; Test - Steinbach Waterpower 8500 Originalbetriebsanleitung

2. Completely loosen the union nut
3. Pull off the supply pipe at the inlet water connection
When removing the hose end of the water pipe, hold it with the opening facing upward so that
residual water in the hose does not uncontrollably run out.
4. Completely loosen the union nut
5. Pull off the drain pipe from the outlet water connection
When removing the hose end of the water pipe, hold it with the opening facing upward so that
residual water in the hose does not uncontrollably run out.
The water pipes are disconnected.
Risk of injury when moving heavy equipment!
The device is heavy! Incorrect lifting or uncontrolled toppling of the device can lead to injuries
or damage the device.
- Always carry or tilt the device with the help of at least one other person, never alone.
- Make sure that your posture is correct (straight back, secure footing, etc.).
- Use transport aids (such as a lifting truck or roller board).
- Wear protective equipment, such as safety shoes or gloves.

Uninstalling the heat pump

Uninstalling the heat pump from its setup location
1. Loosen the fasteners between the feet and the ground anchors.
2. Lift the heat pump off the ground anchors.
The heat pump is uninstalled from its setup location.

Cleaning

Cleaning the device

Wipe the surface with a dry cloth.

Test

Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Are the accessories in flawless condition?
- Are all lines in flawless condition?
- Are the ventilation slots unobstructed and clean?
Do not start up a damaged device or damaged accessories. Have them checked by the manufacturer or
its customer service or a qualified service technician.
Risk of fire and explosion due to leaking finned heat exchanger!
The refrigerant circuit of the finned heat exchanger contains a highly flammable, odorless gas
under high pressure. Risk of fire and explosion due to uncontrolled escaping of refrigerant.
- Keep heat sources and naked flames away from the heat pump.
- Do not burn or drill into the heat pump.
- Do not use any objects other than those permitted by the manufacturer to speed up the
defrosting process.
- Stop using the heat pump immediately if you suspect a refrigerant leak.
- The refrigerant is odorless. Always keep ignition sources away from the installation site of
the heat pump.
on the inlet water connection
2
.
8
on the outlet water connection
2
.
6
CAUTION!
WARNING!
.
8
.
6
45