Manual Defrosting; Key Lock; Calling Up The Temperature Display; Deinstallation - Steinbach Waterpower 8500 Originalbetriebsanleitung

The Timer display shows the time until the next desired end of operation of the heat pump in hours.
22

Manual defrosting

1. Activate the heating operating mode.
The Heating indicator
2. Press and hold the Fan button
Manual defrosting starts. The Heating indicator
3. Monitor the pressure of the refrigerant via the manometer
Manual defrosting takes several minutes. Immediately disconnect the heat pump from the power
source if the refrigerant exceeds the admissible maximum pressure of 4.3 MPa.
Manual defrosting is completed. The Heating indicator
exchanger has been manually defrosted.
Do not use any objects other than those permitted by the manufacturer to speed up the
defrosting process!

Key lock

Activating the key lock
1. Press and hold the Down button
The Key lock indicator
25
Deactivating the key lock
1. Press and hold the Down button
The Key lock indicator
25

Calling up the temperature display

1. Put the heat pump into any operating mode (see "Display" section).
2. Press and hold the Clock button
The temperature of a temperature sensor appears on the display.
3. Press the Clock button
You can switch between the different temperature sensors by pressing the Clock button
(see "Display" section). If there is not input for more than 10 seconds, the temperature display
disappears from the display.
4. Press the ON/OFF button
The temperature display disappears. The display shows the regular operating mode content.

Deinstallation

Disconnecting the lines/pipes

Disconnecting the power supply
1. Put the heat pump into standby mode (see "Display" section).
2. Disconnect the power plug
All display elements on the display
and out of operation.
Disconnecting the water pipes
1. Deactivate the water treatment pump.
44
appears.
20
for about 10 seconds.
14
and the Up button
15
appears. The key lock is activated.
and the Up button
15
disappears. The key lock is deactivated.
for about 10 seconds.
13
.
13
.
18
from the supply line to the power supply.
9
disappear. The heat pump is disconnected from the power supply
C
blinks.
20
during the entire defrosting process.
7
has stopped blinking. The finned heat
20
simultaneously for about 5 seconds.
16
simultaneously for about 5 seconds.
16
again
13