Measuring The Water Hardness; Filter Installation - WMF PERFECTION 800L Serie Bedienungsanleitung

6.1| MEASURING THE WATER
HARDNESS
You must set your machine depending on the
hardness of your water, from 0 to 4. To do this,
follow these instructions:
1| Before using the appliance for the fi st time,
check the hardness of your water so that you
can set the appliance accordingly. This opera-
The details of the classes are given in the table below:
DEGREE OF HARDNESS
° dH
° e
° f
Appliance setting
3| Fill a glass of water and insert a strip (figu e
B1 – B2).
4| Put the strip back out of the glass. After 1
minute read the level of water hardness (fi -
ure B3 – B4).
5| Indicate the number of red zones when con-
figuring the appliance (figu e B6).

6.2| FILTER INSTALLATION

When switching on for the fi st time, the appli-
ance asks if you want to install the filte . If you
wish to do so, select YES and follow the instruc-
tions on the screen.
1| Install the filter in the appliance
2| ONLY screw the filter into the bottom of the
water tank using the accessory supplied with
the filter (figu e A4 – A5).
17
3| Set the month when the filter is fitted (po -
tion 1 on the illustration, left side figu e in
the opening) by turning the grey ring located
CLASSE 0 CLASSE 1
< 3° > 4°
< 3.75° > 5°
< 5.4° > 7.2°
0 – very soft 1 – soft
tion should also be carried out when you use
your machine in a place where the hardness
of the water is different or if you notice a
difference in the hardness of the water.
2| To check the water hardness, use the test
strip supplied with your machine or con-
22
tact your local water authority.
CLASSE 2
> 7°
> 8.75°
> 12.6°
2 – average
hardness
on the upper end of the filte . The month
when the filter should be eplaced is indi-
cated in position 2 on the following illustra-
tion (right side figu e in the opening).
4| Please make sure to fill up the water tank
after filter installation
5| Put a container of 0.6 l under the steam exit (fi -
ure A8). The machine must be primed whether the
filter has been installed or not. This means tha
the water circuits have to be filled. o do this, fol-
low the instructions provided on the screen.
6| The machine will begin by filling the water
circuits, preheating the circuits and then will
complete an automatic rinse. The screen will
inform you when installation is complete.
38
CLASSE 3 CLASSE 4
> 14° > 21°
> 17.5° > 26.25°
> 25.2° > 37.8°
3 – hard 4 – very hard