PowerFlex Bedienungsanleitung Seite 32

CONTROL DISPLAY
2. Mode (display of trip statistics)
With this button you can see three diff erent types of
information:
ODO: overall distance covered on this bike
TRP: number of kilometres covered on this trip only
(day counter).
AVG: average speed over this bike trip.
The ODO mode is the default setting. By pushing
the mode button, you can see the information about
your current bike trip. You can set the day counter
(TRP) on "0" by holding the mode button down for
3 seconds. If you reset the day counter, the average
speed (AVG) is also reset to "0".
3. Drive
If you push this button you switch on walk support
(without pedalling). You use this button if you need
to walk up an incline with your bicycle (to leave bike
storage or a garage for instance). Max. speed up to
6 km/h.
4/5. (+) and (-) button
Using these two buttons you can set the level
of pedaling assistance on the standard display
(15 levels). You can keep pushing the (+) or (-), but
28
MOTOR
if you keep one of those buttons down, the setting
automatically increases with (+) or decreases with (-).
You can use the double display to set 10 levels using
the buttons (+) (–) and choose from three modes
ECO, DRIVE and SPORT using the button MODE
ASSIST (Fig. 21/6).
If you cycle together with somebody else, you can
easily adjust our speed to each other.
6. Wheel circumference setting
The circuit can be set by using the reset button on
the rear side of the display. After pushing the button
all segments start fl ashing. Push any button to
continue. In next step use buttons (+) (-) and DRIVE
to select the bike circuit and confi rm by pushing the
MODE button.
Fig. 05/06
The motor which is designed for Powerfl ex PAS system
is integrated into the front or the rear wheel. Due to its
design, its operation is quiet and it gives enough power
for a comfortable, smooth and safe ride.
www.bikefunint.com