Performing A Channel Search; Reset To Factory Settings - axing UIM 1-00 Betriebsanleitung

Operation instructions | UIM 1-00 | Universal Input Modulator

3.2. Performing a channel search

èYou must perform a channel search on the connected TV sets or search directly for the selected output
channel.
If the station is found, the AXING logo is displayed as the factory setting.
The LCN entered is displayed as the programme number, and the name entered under Service is displayed
as the station name.
Programme
number and
station name

3.3. Reset to factory settings

You can reset the device completely to factory settings.
èPress the reset button for longer than 5 seconds.
The device is rebooted and completely reset to the factory settings.
This also includes the password of the web interface, the IP addresses of the interfaces and the output
channel.
Page 10 of 20 AXING-BA_UIM-1-00.pdf | Technical improvements, changes in design, printing and other errors reserved. | 2021-11-03