Cleaning The Brew Group - Saeco Xelsis Suprema Benutzerhandbuch

Item
Descaling of the
machine

Cleaning the brew group

Regular cleaning of the brew group prevents coffee residues from clogging up the internal circuits. Go
to the 'Status' menu on the screen and select 'Brew group clean' or visit www.saeco.com/care for
support videos on how to remove, insert and clean the brew group.
Cleaning the brew group under the tap
1 Tap the 'Status' icon and scroll to select 'Brew group clean'.
2 Tap the confirmation
Cleaning the brew group with the coffee oil remover tablets
Only use Philips coffee oil remover tablets.
1 Tap the 'Status' icon and scroll to select 'Brew group clean'.
2 Tap the confirmation
Lubricating the brew group
To improve your machine's performance, we suggest that you lubricate the brew group every 2
months, to ensure that the moving parts continue to move smoothly.
1 Apply a thin layer of grease on the piston (grey part) of the brew group (Fig. 31).
2 Apply a thin layer of grease around the shaft (grey part) in the bottom of the brew group (Fig. 32).
3 Apply a thin layer of grease to the guiding rails on both sides (Fig. 33).
Cleaning programs for the internal cappuccinatore
The machines tells you when to clean the internal cappuccinatore.
The machine has three programs to clean the internal cappuccinatore:
- 'HygieSteam Shot': during the preparation of a milk-based drink, the machine automatically shoots
steam through the internal cappuccinatore to rinse it quickly.
- 'HygieSteam': the machine thoroughly cleans the internal milk system with steam. Make sure that
the HygieSteam container is correctly assembled (Fig. 34) and attached to the machine (Fig. 35).
Place the milk tube in the milk tube holder (Fig. 36) and follow the instructions on the screen.
- 'Deep Milk Clean': Perform the 'Deep Milk Clean' procedure with the Philips milk circuit cleaner for a
thorough cleaning of the internal milk system.
Cleaning the internal cappuccinatore under the tap
1 Open the door of the internal cappuccinatore (Fig. 37).
2 Remove the internal cappuccinatore by pulling it down (Fig. 38).
3 Disassemble the internal cappuccinatore by pulling the bottom part off the top part (Fig. 39).
4 Disassemble all parts (Fig. 40) and clean them under the tap.
When to clean
When the machine asks you to
descale
icon to confirm and then follow the instructions on the screen.
icon to confirm and then follow the instructions on the screen.
How to find in the control panel/
What to do
STATUS -> DESCALING. Follow the steps to
descale the machine. When descaling is
needed, the machine asks you to descale it,
press the OK icon to start and follow the
steps.
15
English