Montage; Unfold Scooter And Lock In Upright Position - SoFlow SO1 PRO Originalbetriebsanleitung

3.2 Montage

Assemble your SO1 PRO
copyright by www.soflow.com

Unfold scooter and lock in upright position

Press down on the rear fender, separate the folding hook and fender buckle, then lift the frontbar upright (as shown in the figure).
Once the scooter is locked in the upright position, verify by gently trying to fold.
Detach hook and remove plug inside frontbar
Use the Allen wrench to loosen the screws located at the hook and detach. Once you've removed the hook and screws, make sure to remove the
plug inside of the top of the frontbar.
Place console into frontbar and reattach
Place the console into the top of the frontbar. Make sure that the contact poles between the handlebar and the frontbar are well interlocked. Once
the console is attached, use the Allen wrench to attach the hook back to the frontbar using the two screws.
11