Operation; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL GP-LB 36/210 Li E-Solo Originalbetriebsanleitung

6. Operation

6.1 Switching on the equipment (Fig. 6)
•
To switch on, press and hold the On/Off
switch (2).
•
To switch off, let go of the On/Off switch.
•
Channel the air stream forward and walk slow-
ly to blow foliage or garden refuse into a pile
or to clear out hard-to-reach places.
6.2. Speed control (Fig. 6)
The equipment is fi tted with an electronic speed
controller. To use it, turn the speed controller (Fig.
6/Item 6) to the desired position. Use the equip-
ment only with the speed which is actually requi-
red and never let it run at a speed which is faster
than necessary.
6.3 Turbo mode (Fig. 6)
If you need more blowing power, e.g. to blow away
piles of wet foliage, you can press the turbo button
(Fig. 6 / Item 5). Pressing the turbo button will
raise the speed and therefore the blowing power
temporarily.
Important: To reduce noise and prolong bat-
tery operating time, never actuate the turbo
button longer than necessary.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always remove the batteries before you carry out
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that no
water can seep into the device. The ingress of
water into an electric tool increases the risk of
an electric shock.
Anl_GP_LB_36_210_Li_E_Solo_SPK9.indb 17 Anl_GP_LB_36_210_Li_E_Solo_SPK9.indb 17
GB
7.2 Maintenance
•
Should the tool experience problems beyond
those mentioned above, let only an authorised
professional or a customer service shop per-
form an inspection.
•
There are no other parts inside the equipment
which require maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8. Faults
The equipment does not work:
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to the customer service address
below.

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should be
taken to a suitable collection center for proper dis-
posal. If you do not know the whereabouts of such
a collection point, you should ask in your local
council offi ces.
10. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempera-
ture is between 5 and 30 °C. Store the electric tool
in its original packaging.
- 17 -
23.08.2021 10:02:03 23.08.2021 10:02:03