Zipro Neon Bedienungsanleitung Seite 24

3b. Fix the left pedal base (5L) to the crank (22) with the left pedal base pin (38L), washers (62),
spring washers (41), and the left nylon nut (42L). Do not tighten all the elements yet.
3c. Fix the left handle arm (6L) to the left pedal base (5L) with hexagonal bolts (30), flat washers
(31) and the nut (32). Put nuts (23)(57) on the upper and lower part of the handle arm and nuts
(43) on the rear part of the left pedal base (5L) to cover the fixing bolts.
3c. Fix the left handle arm (6L) to the left pedal base (5L) with hexagonal bolts (30), flat washers
(31) and the nut (32). Put nuts (23)(57) on the upper and lower part of the handle arm and nuts
(43) on the rear part of the left pedal base (5L) to cover the fixing bolts.
3d. Repeat steps 3a, 3b, and 3c for the right handle arm (6R) and right pedal base (5R).
3e. Fix the left and right pedal (10L/R) to the pedal base (5L/R) with hexagonal bolts (33), flat
washers (34), and nuts (35).
3f. Tighten all elements.
Note: Screw the left pedal base pin (38L) counterclockwise. Screw the right pedal base pin
(38P) on clockwise.
Note: The right pedal base is marked 'R' and the left pedal base is marked 'L'.
4. Install the handlebar
Run the heart rate measurement
cable (50) through the handlebar
column (2) and through the
computer bracket opening.
Fix the handlebar (8) to the front
column (2) using hexagonal bolts
(51), flat washers (31) and spring
washers (52). Fix the handlebar
cover (53).
Screw the left and right handle
(7L/R) to the left and right handle
arm (6L/R) with bolts (45), curved
washers (44) and nuts (58).
EN
24