Concept Ferratte ZN8007 Bedienungsanleitung Seite 35

EN
OPERATING INSTRUCTIONS
Do not leave the unit unattended if it is connected to the power source.
Remove all the stickers and packaging from the ironing surface before the first use.
Before the first ironing, try the unit on a piece of old fabric to make sure the ironing surface and water tank are perfectly
clean.
The unit may emit a slight odor during the first use. This smell will vanish after a short time.
Filling with water
1. Unplug the unit from the power source.
2. Set the temperature controller to the minimum.
3. Open the filling hole cover (Fig. 1)and fill the tank with water. Use only distilled
or boiled water. Don't fill the tank with a liquid other than water. Do not put any
additions in the water. There is a risk of damage to the unit. The capacity of the
tank is about 350 ml. Do not exceed the maximum marked water level.
4. Close the filling hole cover.
Spraying
Push the spray button; water is released through the spray nozzle. You will need
a sufficient volume of water in the tank to activate this function.
Steam ironing
1. For steam ironing set the steam volume regulator to the minimum, and the
temperature controller according to the material „ ...", „ ..." or „ MAX"
2. After the heating indicator goes off, set the steam volume regulator to the
required position, the steam will start to release, and you may begin ironing.
Steam shock
Turn the temperature controller to the position „ ..." or „ MAX", and push the steam
button – the ironing surface will emit steam. Wait for a couple of seconds before
the next push.
You may use this function for ironing in a vertical position to smoothen folds on
hanging clothes or curtains. Hold the unit several centimeters from the fabric to
prevent damage to soft materials.
Never iron any clothing on the body!
Ironing
1. If you want to use the spray or steam function, fill the tank with water (see
Filling with Water).
2. Set the temperature controller to the minimum.
3. Insert the plug into the mains outlet.
4. Set the temperature controller to the value that corresponds to the material to
be ironed (according to the international textile codes). The heating indicator
will be illuminated.
Note: Iron fabrics that require a lower temperature first, then those at higher
temperatures. Most fabrics are marked according to international codes – see
the table below.
ZN8007, 8009
Fig. 1
33