Installation Instructions - Thermalright Macho Rev. A BW Bedienungsanleitung

All manuals and user guides at all-guides.com

Installation Instructions:

Step 1:
Step 1 : Part Installation
Take out Macho cooler from the paper box.Remove the TY-147A from the cooler by pulling the Fan
Clips upwards in order to give room for ease of installation. And leave the Fan Clips on the Heatsink
Body. Do not remove them. Apply Anti-Vibration Padding to 4 corners on the Heatsink Body.
Step 2:
Step 2 : Backplate Installation
Choose the platform (775/1150/1151/1155/1156/1366) you are in use. Make four M3L10 Screw Pillars
go through the Metal Back Plate and the Mylar film from bottom towards top.And then place the Metal
Back Plate on the table. Put the four Washers (for Intel) around the Screw Pillars.
Step 3:
Step 3 : 775 backplate cap
Note: When installing on a 775 platform, please
first insert the Back Plate Cap into the opening on
the Back plate, make sure you have the Cap facing
downwards. (Only for 775).
3
1366
775
Step 4:
1
Step 4 : Screw Cylinder Installation
Place the motherboard on top of the Back Plate.
See the four Screw Pillars go through the four holes
around the processor socket.Cap the four Screw
Pillars with the four Screw Nuts.Make sure the side
with a washer is facing the Back Plate.
1150
1151
1155
1156
4
2
3