Thermalright Macho Rev. A BW Bedienungsanleitung Seite 17

All manuals and user guides at all-guides.com
Installation Instructions:
Step 1:
Step 1 : Part Installation
Take out Macho cooler from the paper box. Remove the TY-147A from the cooler by pulling the Fan
Clips upwards in order to give room for ease of installation. And leave the Fan Clips on the Heatsink
Body. Do not remove them. Apply Anti-Vibration Padding to 4 corners on the Heatsink Body.
Step 2:
Step 2 : Backplate Installation
Choose the platform AMD AM3/AM4 you are in use. Make four M3L10 Screw Pillars go through the
Metal Back Plate and the Mylar film from bottom towards top. And then place the Metal Back Plate on
the table. Put the four Washers (for AMD) around the Screw Pillars.
Step 3:
Step 3 : Backplate cap
Note: When installing on a 939 platform, please
first insert the Back Plate Cap into the opening
on the Back plate, make sure you have the Cap
facing downwards. (Only for 939).
11
Step 4:
1
3
Step 4 : Screw Cylinder Installation
Place the motherboard on top of the Back Plate.
See the four Screw Pillars go through the four
holes around the processor socket.Cap the four
Screw Pillars with the four Screw Nuts.Make sure
the side with a washer is facing the Back Plate.
AM4
AM3
4
2