Eufab 11583 Bedienungsanleitung Seite 12

5. INSTRUCTIONS FOR USE
5.1 OVERVIEW
1 Wheel rail left
2 Wheel rail right
3 Frame holder
4 Safety strap, long
5 Assembly material
6 Cable ties
7 Tensioning strap, short
5
5
Figure 2: Overview
12
4
5.2 ATTACHING THE EXTENSION
NOTE
Before fi tting the extension to your bicycle
rack, disconnect the electrical cables from
the base frame of the bicycle rack by cutting
through the cable ties with cutting pliers.
Step 1:
Remove the brackets for the lamp holders from the
outside of the base frame (left and right).
1
2
7
3
Figure 3: Removing the retaining clips
Step 2:
Remove the retaining screws from the base frame.
6
(Left and right).
Figure 4: Removing the retaining screws
Step 3:
Pull the frame extension with the licence plate holder
and the lamp holders out of the base frame until the
second pair of holes in the extension coincide with the
holes in the base frame.
Figure 5: Pulling out the frame extension
Fig. 1
Fig. 2
Fig. 3