Input Connection And Extension - dB Technologies DVA K5 Bedienungsanleitung

INPUT CONNECTION AND EXTENSION

FIRST DVA K5 MODULE
• Connect the cable from MIXER/LINE to the BALANCED AUDIO (1) input of the first
line array module. For this purpose, use a cable equipped with an XLR connector (not
included in the supply). For further information about the cables that are available
please refer to the picture at p. 37.
• Extend the signal between the first and the second module. To this purpose connect
the OUTPUT/LINK (2) output to the BALANCED AUDIO (1) input of the second module.
• Repeat the operation between the second and the third module, and so on, until all
line-array modules are connected.
DVA K5
MIXER/LINE
!
ATTENTION
• Only use cables equipped with Neutrik® connectors
• Replace any damaged cables, to avoid malfunctions and
poor sound quality.
SECOND DVA K5 MODULE
LINK
Code 420120232 REV.1.1
English
37