Eibenstock BST 182 V/S Originalbetriebsanleitung Seite 20

Angled drilling
Drilling with Water
If you are cooling the drill bit with water a water collection ring is recommended.
This will be mounted with a latch fastener on the screws of the base plate and
ensures a clean drilling. Mainly for overhead or lateral drilling. (see spezial-
accessories page 13)
Demounting the core drill unit
 Move the machine holder with the core drill upwards until it locks in the final
top position.
 Remove the drill bit.
 Loosen the clamping screw at the machine holder and remove the core drill
machine from the drill rig. (see page 17)
 Loosen the fastening nut (F). (see page 15)
 While doing so, hold the drill rig firmly!
 Remove the drill rig.
 Unscrew the quick action clamping screw (D). (see page 15)
 Remove the screw (1), which locks the pillar
at 90°.
 Loosen the two side screws (2) on the base
plate.
 Loosen the clamp (3) on the support with the
help of the feed lever.
 Now turn the column until the desired angle.
Tighten the 2 screws (2) and the clamp (3)

again.
The scale on the toothed column makes adjusting
the drilling angle easier.
19