General Notes; Camera Function - geo-FENNEL GeoDist 80 Bedienungsanleitung

GENERAL NOTES

· After 3 minutes without operation the instruments powers off automa-
tically.
· The instrument automatically saves the last 1.000 measured values.
· The integrated tilt sensor 360° is always active.
· In all measuring modes (except single and continuous measurement)
the red line shows which parameter will be measured next. The green
L shows the parameter to be determined.

CAMERA FUNCTION

Press to activate the camera function in all measuring modes, in
case the target is not visible with the eye - especially in case of
outdoor measurements.
= zoom in/out
Start the measurement with
MEASURING REFERENCE
Press and select
Confirm the required measuring reference with
FRONT TRIPOD
.
with .
REAR
.
EN
31