Installation And Connection; Installation Guidelines; Preparing For Installation - Balluff BTL7-P511-M Serie Betriebsanleitung

BTL7-P511-M _ _ _ _ -BE/BF/CE/ZE/ZF-S32/S115/KA _ _ /FA _ _
Magnetostrictive Linear Position Sensor — Rod Style
4

Installation and connection

4.1

Installation guidelines

Non-magnetizable material
Non-magnetizable material
Magnet
Min. Ø D2 = Minimum diameter of the bore (see Tab. 4-1)
1)
Fig. 4-1: Installation in non-magnetizable material
Magnetizable material
If using magnetizable material, the BTL must be protected
against magnetic interference through suitable measures
(e.g. spacer ring made of non-magnetizable material, a
suitable distance from strong external magnetic fields).
Magnet Spacer ring made of non-magnetizable
material
Magnet Spacer ring made of non-magnetizable
material
Min. Ø D2 = Minimum diameter of the bore (see Tab. 4-1)
1)
Fig. 4-2: Installation in magnetizable material
Rod diameter
10.2 mm
12.7 mm
Tab. 4-1: Bore diameter if installed in a hydraulic cylinder
www.balluff.com
Bore diameter D2
At least 13 mm
At least 18 mm
4.2

Preparing for installation

Installation note: We recommend using non-
magnetizable material to mount the BTL and magnet.
Horizontal assembly: for horizontal assembly with
nominal lengths > 500 mm, support the rod and tighten it
at the end if necessary.
Hydraulic cylinder: If installed in a hydraulic cylinder,
ensure that the minimum value for the bore diameter of the
support piston is complied with (see Tab. 4-1).
Mounting hole: BTL threads are M18×1.5 (per ISO),
M22×1.5 (per ISO) or 3/4"-16UNF (per SAE). Depending
on the version, a mounting hole must be made before
assembly.
Fig. 4-3: Mounting hole M18x1.5 per ISO 6149 O-ring 15.4x2.1
Fig. 4-4: Mounting hole 3/4"-16UNF per SAE J475 O-ring 15.3x2.4
2.4+0.4
Fig. 4-5: Mounting hole M22×1.5 per ISO 6149 O-Ring 19.3×2.2
Magnet: Various magnets are available for the BTL (see
Accessories on page 18).
english 9