FALMEC Modula M2 Gebrauchsanweisung Seite 32

ELECTRICAL CONNECTION
(only intended for qualified personnel)
Disconnect the appliance from the electrical mains before carrying
out any operation on it.
Make sure that wires inside the appliance are not disconnected or
cut: otherwise, contact the nearest Servicing Centre.
Refer to qualified personnel for electrical connections. Connection must
be carried out in compliance with the provisions of law in force.
Before connecting the Teppan Yaki to the mains, check that:
• the mains voltage corresponds with that indicated on the data plate;
• the electrical system is up to standard and can withstand the load;
• the power supply plug and cable do not come into contact with temperatu-
res exceeding 70 °C;
• the power supply system is effectively and properly connected to earth in
compliance with regulations in force;
• the socket used to connect the cooker is within reach.
In case of:
• devices fitted with cables without a plug: the type of plug to use is a "stan-
dardised" one. The wires must be connected as follows: yellow-green for ear-
thing, blue for neutral and brown for the phase. The plug must be connected
to an adequate safety socket.
• fixed appliance not provided with a power supply cable and plug, or any
other device that ensures disconnection from the electrical mains, with an
opening gap of the contacts that enables total disconnection in overvoltage
category III conditions.
Said disconnection devices must be provided in the mains power supply in
compliance with installation regulations.
The yellow/green earth cable must not be cut off by the switch.
The Manufacturer declines all responsibility for failure to comply with the safety
regulations.
OPERATING AND USING THE TEPPAN YAKI
Control Description
Teppan Yaki switch-on and off
Increases the power level
Decreases the power level
Timer selection for timed switch-off of the Teppan Yaki
(from 1 – 99 minutes)
Front and rear heating zones
Display: indicates the power level (1 – 9) or timer (1 – 99)
Press the and
+
keyboard lock. Press the
the keyboard
The Teppan Yaki allows you to cook on the entire plate or in the front or back
part, with a temperature adjustment from 0 to 250°C, using a touch keypad.
Teppan Yaki allows you to cook meat, fruit, vegetables, etc. using just a little
vegetable fat (butter, oil, lard).
Thoroughly clean the appliance before and after each use.
First switch-on:
• Thoroughly clean all the components
• Heat the plate for about 10 minutes without placing any items or food. The
appliance could emit smoke and odours; this way, the grease used to treat
the heating elements is eliminated
• Ventilate the room
keys simultaneously to activate the
and keys again to unlock
USING THE TEPPAN YAKI
Switch the Teppan Yaki on
Select the desired power using the
and keys in the desired area.
ATTENTION: if only part of the
Teppan Yaki is used, the other part will
also heat up partly by contact.
If you want to use the entire Teppan Yaki
at the same temperature: set the desired
power on both zones.
Wait a few minutes to allow the plate to
warm up.
Grease the plate and place the
dish to be cooked.
Turn the food only when it detaches
easily from the plate.
ATTENTION: do not scratch the
Teppan Yaki with the utensils.
Switch the Teppan Yaki off once cooking
is completed.
The display shows " " for about 1 h after
switching off.
ATTENTION: the Teppan Yaki is not
necessarily cold if " " does not appear
on the display. The plate remains hot for
at least 2 h. Do not come into contact
with these parts without adequate perso-
nal protection.
Cooking tips
• Distribute the food evenly and
homogeneously over the entire
cooking surface
32
• Do not cut the food on the Tep-
pan Yaki. Prepare the pre-cut
food into small portions