Automatic­pairing; Manual­pairing - Grundig GSB 950 Bedienungsanleitung

CONNECTION
Connect­Power
Risk­of­product­damage!
▪
Ensure that the power supply voltage
corresponds to the voltage printed on the
back or the underside of the unit.
▪
Before connecting the AC power cord,
ensure you have completed all other
connections.
Soundbar
Connect the mains cable to the AC~ socket of
the main unit and then into a mains socket.
Subwoofer
Connect the mains cable to the AC~ socket of
the Subwoofer and then into a mains socket.
Note:
▪
If there is no power, ensure the power cord
and plug are fully inserted and the power is
turned on.
▪
Power cord quantity and plug type vary by
regions.
Pair­up­with­the­subwoofer
Automatic­pairing
Plug the Soundbar and the subwoofer into the
mains sockets and then press
remote control to switch the unit to On mode. The
subwoofer and Soundbar will automatically pair.
▪
When the subwoofer is pairing with the
Soundbar, the Pair indicator on the subwoofer
will flash fast.
▪
When the subwoofer is paired with the
Soundbar, the Pair indicator on the subwoofer
will light up steadily.
▪
Pair
Do not press on the rear of the subwoofer,
except for manual pairing.
Manual­Pairing
If no audio from the wireless subwoofer can be
heard, manually pair up the subwoofer.
1­­Unplug both units from the mains sockets again,
then plug them in again after 3 minutes.
2­­
Press and hold the PAIR button on the rear of
the subwoofer for a few seconds.
» The Pair indicator on the subwoofer will
rapidly blink.
­ 3 0 ENGLISH
­ - ---------------------------------------------------------------------------------------------------------------------
3­­
4­­
5­­
NOTE:
▪
▪
▪
on the unit or
▪
Then press on the unit or remote control to
switch the unit ON.
» The Pair indicator on the subwoofer will
become solid when successful.
If the Pair indicator still keeps blinking, repeat
step 1-3.
If the Pair indicator blinks, the wireless
connection has failed. Unplug the cable of
the subwoofer and then reconnect the main
cable after 4 minutes. Repeat step 1 ~ 4.
The subwoofer should be within 6 m of the
Soundbar in an open area (the closer the
better).
Remove any objects between the subwoofer
and the Soundbar.
If the wireless connection fails again, check
if there is a conflict or strong interference (e.
g. interference from an electronic device)
around the location. Remove these conflicts
or strong interferences and repeat the above
procedures.
If the main unit is not connected with the
subwoofer and it is in ON mode, the Pair
Indicator on the subwoofer will blink slowly.