Connection To Main Power Supply; Switching On Your Receiver; Starting The Unit For The Fi Rst Time - Rt IDL7000m SCI Bedienungsanleitung

1.2. Connection to main power supply

After all the connections are done you can connect your digital receiver to the main power. Just before plugging a power cable into the
wall connector put the power switch, on the rear panel (17), in position 0.

1.3. Switching on your receiver

Switch the power switch, (17) on the rear panel, to the position "I".
The satellite receiver is now switched on and starting (the message "Booting up" is shown on the display). This can take around 20
seconds. From now on, you can switch your receiver on or to standby using the "Standby" key on the remote control or on the front
panel of the receiver.
Note:
Behaviour of the receiver after switching on or power up depends on the "Power-up Mode" settings (see chapter 4.1.1.11 Power Up
Mode)
1.4. Starting the unit for the first time:
When you install your receiver for the fi rst time or when you do a factory
reset, you will enter in the fi rst installation mode. The unit will ask you to go
through the following steps to setup the unit for proper operation (to record
and watch services):
Step1: after the fi rst power up or factory reset (in user menu):
The quick start guide menu displayed:
Select your country:
• press "select", then "up/down" keys of your remote control to select the
country,
• then press again to validate your choice
• Select your language:
• press "select", then "up/down" keys of your remote control to select the
country,
• then press again to validate your choice
Once your selections are OK, press Exit on the remote control.
Step2:
A new menu is displayed: User Preferences
In general, you do not need to modify the settings in this display.
If you want to set up specifi c settings, then modify the lines according to
your preferred settings, using the remote control.
Once your selections are OK, press Exit on the remote control.
Step3:
Signal strength and signal quality bars
In two level bar meters, on the right side of the screen, the user can see
the strength and quality of the signal coming from the antenna dish to
the tuners. These two meters can be used while doing a fi ne-tuning of
the antenna position. The antenna has to be adjusted to have maximum
possible signal strength and signal quality.
8