Change Pin Code; Sleep Timer; Conditional Access System - Rt IDL7000m SCI Bedienungsanleitung

4.5.2. Change Pin Code

Selecting this option user will be asked to enter a pin code before
entering. After typing a valid pin code, a new pop-up opens (see
picture 40). Here user is able to enter a new pin code. After entering a
fourth digit, user will be asked to repeat a new pin code. Next pop-up
will inform user if pin code changes is done successfully of not.
Note:
The valid pin code default value is '1111'.
Note:
In case that you forgot your pin code, call customer service.

4.6. Sleep timer

You can use the Sleep timer to specify a time (e.g. at night) at which
the receiver is to switch to the standby mode. This is particularly
useful if there is no person available at this time to switch receiver
manually to the standby mode.
Pressing a "Menu" key (4) + "Sleep timer" or pressing a "Sleep timer"
key (31), a sleep timer pop-up will be open (see picture 41).
Using direction "Up" and "Down" keys user can set the time, at which
the receiver should switch to the standby mode automatically. Time
setting is in 15-minute steps. At the end, press the "OK" key (6) or
"Exit" key (22) to confi rm a selection. The Sleep Timer is active with
immediate effect, and will count backwards the time to 00:00.
To switch off a sleep timer, before 00:00 time, user has to enter to this
menu end manually return time to 00:00.
Note:
Switching to the standby mode, the digital receiver is able to switch off
also some of the TV sets that use "Slow Blanking" signal on a SCART connector.

4.7. Conditional access system

The look of the "Conditional access system" menu depend form the
CI modules and CA smart card inserted in slots 12 and 14 on the front
panel. One of the possible versions is shown on picture 42.
In your digital receiver is embedded Conax conditional access system.
That means user needs only a valid Conax smart cart without any CI
modules.
Selecting options 1 or 2 will take you to a display that is generated
by the MMI (Man Machine Interface) of the CI module itself, and may
therefore differ slightly in appearance from one module to the other.
In order to obtain a full display of the data, a smart card must be
inserted in the module. Please consult your installer or card provider
for the details of the use of your specifi c card.
While inserting and removing a CI module or CA card, following
messages will be displayed on the screen of your TV set:
CI Init – After inserting of a CI module, the initialisation of the module
start.
CI Init OK – Initialisation of the CI module is done successfully.
CI Init Error – Initialisation of the CI module is not done successfully.
CI Card Removed – CI module is removed from the slot.
CA Card Inserted – CA card is inserted in slot
CA Card Removed – CA card is removed from the slot.
Incorrect Conax card – A not valid Conax CA card is inserted in the
slot
No card inserted – The card is not inserted when needed or
32
Picture 40
Picture 41
Picture 42