B.3.3 Informationen Zur Funkzulassung Fcc Und Ic - Siemens SIPART PS100 Betriebsanleitung

B.3.3 Informationen zur Funkzulassung FCC und IC
Canada Regulatory Information
1. This device complies with Industry Canada's applicable licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of thedevice.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence.L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptibled'en compromettre le fonctionnement.
2. This product is certified as type of the portable device with Industry Canada Rules. To
maintain compliance with RF Exposure requirement, please use within specification of this
product.
Ce produit est certifié comme type de l'appareil portable avec Industrie Règles de Canada.
Pour maintenir l'acquiescement avec exigence Expositionde RF, veuillez utiliser dans
spécification de ce produit. -IC: 4389B-EYSHJN
3. Please notify certified ID by either one of the following method on your product.
-Contains IC: 4389B-EYSHJN
Specifiez ID certifiée dans votre produit par une de méthode suivante.
-Contains IC: 4389B-EYSHJN
FCC Regulatory Information
1. This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
2. Please notify certified ID by either one of the following methods on your product.
-Contains Transmitter Module FCC ID: RYYEYSHJN
-Contains FCC ID: RYYEYSHJN
3. CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the use's authority to operate the equipment.
4. This product is certified as type of the portable device with FCC Rules. To maintain compliance
with RF Exposure requirement, please use within specification of this product.
5. The antenna used for this transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
6. This module can change the output power depending on the circumstances by the
application software which is developed by module installer. Any end user cannot change the
output power.
SIPART PS100
Betriebsanleitung, 05/2021, A5E45863537-AE
Bluetooth
B.3 Technische Daten
77