Self Diagnosis - Valeo Beep & Park Vision Bedienungsanleitung

Technical Parameters / Rearview camera
•
Type/Mode: CMOS camera
•
Video standard: PAL
•
Voltage: DC 12V
•
Picture element: 640 (H) x 480 (V)
•
Horizontal resolution: 450 TV lines
•
Minimum illumination: 1 Lux
•
View angle: 110°x90° (HxV)
•
Operation temperature: Camera -30°C ~ +80°C
Technical Parameters / Display
•
Type: TFT screen
•
Size: 3'' (16:9)
•
Display format: 400 (H) x 240 (V)
•
Number of pixels: ~96 000
•
Video mode: NTSC/PAL
•
Working current: 250 mA
•
Static current: 110 mA
•
Working temperature: -20°C ~ +60°C
No reset necessary
4
Caution
•
It is recommended that installation is carried out
approved professional auto technician.
•
It is strongly advised to check the position of the sensors
before the definitive drilling of the holes.
•
beep&park®/vision™ helps
reversing and parking. Driving skills, such as slowing down,
use of mirrors etc. are always essential.
•
You may have to replace the adapter ring (included in the kit)
around the sensor in order to obtain the required inclination
in the range of +/- 5° after installation on the vehicle bumper.
•
The angle of the camera should be adjusted using the angle
correction rings provided.
•
To ensure clear view, please keep the camera lens clean and
keep it away from sharp items.
•
If you wish to connect the system to an original navigation
system, please refer to your auto technician.
•
Please ensure waterproofness of the camera in case it would
be fitted outside the bumper.

Self diagnosis

This system is equipped with a self-diagnosis of
sensors:
1. When the reverse gear is selected, the system automatically
tests the 4 rear sensors.
2. If all of the sensors are working, the system beeps once.
3. If there is a problem with any of the sensors, the system
beeps 3 times.
4. C heck that sensors are properly fitted.
5. In case of crash, you can replace the concerned sensor by
one available in the Valeo spare parts offer.
by an
provide assistance when