Disassembly On The Ventilation Side - Elmo Rietschle G-Serie Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
8.10

Disassembly on the ventilation side

▪ Hang the lifting device into the lifting eyes of the motor housing (001).
▪ Lift the motor housing (001) out of the assembly device (A).
▪ Place the motor housing (001) down horizontally.
▪ Remove the lifting device.
▪ Remove the screws (451).
▪ Remove the nuts (459) from the pockets in the motor housing (001).
▪ Pull the end plate (450) off the motor housing (001) and remove.
Use two slotted screwdrivers to remove it if necessary.
▪ Remove the spring washer (467) from end plate (450).
▪ Remove the radial shaft seal (452) from the end plate (450) and note the instal-
lation position.
35 / 64
Tel. 071 918 60 60, Mail: v-g@prematic.ch
Disassembly
09.2013 · 610.44495.40.320
8