Disassembling The Rolling Bearing On The Compressor Side - Elmo Rietschle G-Serie Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
8.4

Disassembling the rolling bearing on the compressor side

▪ Block the impeller (027) to stop it turning without damaging it.
▪ Remove the screw (029).
▪ Remove washer (069) and washer (078) and mark the installation position.
▪ NOTICE! Screw a screw of the correct size into the threaded hole in the
rotor (005) to protect it from damage.
▪ Remove the rolling bearing (007) and bearing cover (010) using the bearing
puller (B) and mark the installation position.
29 / 64
Tel. 071 918 60 60, Mail: v-g@prematic.ch
Disassembly
09.2013 · 610.44495.40.320
8